[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
2 way / 3 way Switching Question
- To: ukha_d@xxxxxxx
- Subject: 2 way / 3 way Switching Question
- From: lardfest@xxxxxxx
- Date: Wed, 11 Jul 2001 10:08:04 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
I am planning on installing some X10 switches t replace some lights
in the hall and on the landing.
I have two scenarios:
1) I have hall lights controlled by 2 seperate switches, I plan t
install a LW10 at one end and an SS13 (RF X10 switch at the other)
over the second.
This is t avoid pulling up the floorboards t install an LD10. PLus
I can use the other switches on the SS13 t trigger other X10 macros.
2) Upstairs I have a landing light controlled by 3 seperate switches.
Again I plan t install an LW10 on 1 switch point, and SS13 over the
second and a blanking plate on the third.
My question is, what do I do with the wires at each blanking point?
Do I just terminate them in connector blocks, effectivly leaving them
switched off?
Thanks for your help!
Neill
____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________
Your use of Yahoo! Groups is subject t http://docs.yahoo.com/info/terms/
Home |
Main Index |
Thread Index
|