The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: 2 Way


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: 2 Way
  • From: "Paul Miller" <pmiller@xxxxxxx>
  • Date: Fri, 16 Feb 2001 21:04:46 -0000
  • Delivered-to: rich@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

1) correct

2) & 3) I think you may be getting confused because there is a company
called x10 as well as the protocol x10 (how the device talk to each other
across the mains). forgetting about the company, not all devices can send
and receive commands; e.g for UK models

UNIT				Send			Receive

Appliance modules 	N			Y
Light Modules		N			Y
Light Switches		N			Y
Motion Detectors		Y			N
Maxi Controllers		Y			N
Mini Controllers		Y			N

Is that any clearer?

Paul



-----Original Message-----
From: Nigel friery [mailto:nigel@xxxxxxx]
Sent: 16 February 2001 20:53
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] 2 Way


Thanks but a little confused

If I read it right

1) HV has the functionality to cope.

2) In Uk non "X10 manufactured" units can send a X10 command.

3) But X10 "manufactured" units cannot.

If I am correct where can I purchase controllers such as light switches
which do work ?

Thanks

Nigel


-----Original Message-----
From: Paul Miller [mailto:pmiller@xxxxxxx]
Sent: 16 February 2001 20:20
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] 2 Way


HV will listen for other devices sending a X10 command and then alter the
X10 status within HV to reflect the change.

BUT, in the UK only other controllers or motion detectors, keypads etc can
SEND a X10 command the standard units such as appliance modules, light
modules and light switches cannot send X10 commands hence they cannot show
they have been switched on by a local control.



-----Original Message-----
From: Nigel friery [mailto:nigel@xxxxxxx]
Sent: 16 February 2001 20:28
To: UKHA
Subject: [ukha_d] 2 Way


Does anyone know,

In a UK setup using Homevision and X10 units.

The Homevision spec states it "monitors" the X10 units for their
state
(on/off etc).

Is this still true for the UK spec X10 units.

Thanks

nigel















Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.