RE: 2 Way

["Nigel friery" <nigel@xxxxxxx>]

Thanks but a little confused

If I read it right

1) HV has the functionality to cope.

2) In Uk non "X10 manufactured" units can send a X10 command.

3) But X10 "manufactured" units cannot.

If I am correct where can I purchase controllers such as light switches
which do work ?

Thanks

Nigel


-----Original Message-----
From: Paul Miller [mailto:pmiller@xxxxxxx]
Sent: 16 February 2001 20:20
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] 2 Way


HV will listen for other devices sending a X10 command and then alter the
X10 status within HV to reflect the change.

BUT, in the UK only other controllers or motion detectors, keypads etc can
SEND a X10 command the standard units such as appliance modules, light
modules and light switches cannot send X10 commands hence they cannot show
they have been switched on by a local control.



-----Original Message-----
From: Nigel friery [mailto:nigel@xxxxxxx]
Sent: 16 February 2001 20:28
To: UKHA
Subject: [ukha_d] 2 Way


Does anyone know,

In a UK setup using Homevision and X10 units.

The Homevision spec states it "monitors" the X10 units for their
state
(on/off etc).

Is this still true for the UK spec X10 units.

Thanks

nigel