[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: PC suitable for HA controller?
- To: ukha_d@xxxxxxx
- Subject: Re: PC suitable for HA controller?
- From: "Paul Gordon" <paul_gordon@xxxxxxx>
- Date: Thu, 08 Feb 2001 20:01:05 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
Sorry in advance for turning this list into a garage sale...
OK, I've "rummaged" through the spares cupboard, and uncovered
the following
drives, free to anyone for the cost of sending them...
(Mark M already has dibs on the IDE ones...)
SCSI: (narrow, 50-pin)
Seagate Barracuda ST32550N x 2 (2.1GB)
Connor CFP2105S x 1 (2.1GB)
Wide-SCSI: (68-pin)
IBM DORS-32160 x 3 (2.1GB)
Seagate ST15150W x 1 (2.1GB - 2" form factor - sounds like a Harrier
jump-jet when it spins up...)
IDE:
Western Digital Caviar 2850 x 1 (850MB)
Samsung PLS-30854A x 1 (850MB)
All are 3.5" x 1" form factor, except for the one mentioned
above, all were
working last time I took them out of the machines they were in...
I Also have a P90 motherboard (with P90 fitted) if anyone's interested..
Oh, and I know I have one or two external 3.5" SCSI drive enclosures
somewhere (in the loft I think) with integral PSU's, external SCSI-ID
switch, and twin micro-D connectors.
Also, while were in "swap-shop" mode, don't suppose anyone has a
spare 2.5"
IDE drive perchance? - or knows where I can get one cheap? - don't
especially care about the size, but I've got a perfectly good Toshiba Tecra
550CDT laptop that has a dead disk.... (I'd like to get it set up as a HA
controller on my bedside table or something...)
Cheers all.
Paul G.
>From: "Mark McCall" <Mark@xxxxxxx>
>Reply-To: "Mark McCall" <Mark@xxxxxxx>
>To: <paul_gordon@xxxxxxx>
>Subject: Re: [ukha_d] PC suitable for HA controller?
>Date: Thu, 8 Feb 2001 18:14:55 -0000
>
>Paul
>
>I could use a couple of the IDE drives if possible?
>
>Thanks
>
>M.
>
>----- Original Message -----
>From: Paul Gordon <paul_gordon@xxxxxxx>
>To: <ukha_d@xxxxxxx>
>Sent: Wednesday, February 07, 2001 11:47 PM
>Subject: Re: [ukha_d] PC suitable for HA controller?
>
>
> > <Free Hardware Offer>
> >
> > Errm, I have a stash of all my old hard disks lying around in my
junk
> > cupboard, which I seriously am never likely to use again. (but I
never
>throw
> > anything out!)
> >
> > I know I have a bunch of SCSI disks, all 2GB, most wide-SCSI
(68-pin
> > connector), but there might be one or two narrow-SCSI (50 pin).
As for
>IDE
> > ones, unfortunately most of my stash are just 850MB ones, and I
can't
> > remember how many I've got left, as I have been pulling them
apart to
>use
>as
> > fridge magnets!!
> >
> > Free to anyone who thinks it's worth the cost of the postage...
> >
> > <End free hardware offer>
> >
> > Paul G.
> >
> >
> >
> > >From: "Oliver Pell" <odp@xxxxxxx>
> > >Reply-To: ukha_d@xxxxxxx
> > >To: <ukha_d@xxxxxxx>
> > >Subject: Re: [ukha_d] PC suitable for HA controller?
> > >Date: Wed, 7 Feb 2001 23:27:57 -0000
> > >
> > ><snip>Haven't a clue what it would be worth though?
> > >
> > >Not much ;-). Seriously, a P-Pro 200 should probably be fine
unless you
> > >want
> > >to run voice recognition. The 1GB HDD might be more of a
problem -
>though
> > >it
> > >depends what OS you want, of course. If you want to run a
reliable
>version
> > >of Windows (i.e. NT/2000) or a more than minimal install of
Linux then
>I'd
> > >recommend factoring in the cost of buying an new hard disk as
well.
> > >
> > >Cheers,
> > >
> > >Oliver.
> > >
> > > >-----Original Message-----
> > > >From:
> > >
> > >
> >sentto-1109639-6796-981587670-mark=automatedhome.co.uk@xxxxxxx
> > > >om
> > >
> > >
> >[mailto:sentto-1109639-6796-981587670-mark=automatedhome.co.uk@xxxxxxx
> > > >nelist.com]On Behalf Of Mick Furlong
> > > >Sent: Wednesday, February 07, 2001 11:13 PM
> > > >To: ukha_d@xxxxxxx
> > > >Subject: [ukha_d] PC suitable for HA controller?
> > > >
> > > >
> > > >I have a chance to get an old PC which I would like to
use as a HA
> > > >controller.
> > > >
> > > >Specification is Pentium Pro 200. 128mb ram, 1gb ide
disc.
> > > >
> > > >Interestingly it has 4x PCI and 4xISA slots (1
shared), so loading
>it
> > > >up with expansion cards such as Sound and Serial Ports
is easy (i
>have
> > > >an odd mix of cards around so the mix of slots is
handy.
> > > >
> > > >Could someone advise on the pros and cons od using
this PC for HA
>and
> > > >also whether the system is actually worth paying any
money for?
> > > >
> > > >Thanks in advance
> > > >
> > > >Mick
> > > >
> > > >
> > > >
> > > >
> > > >
> > >
> > >
> > >Yahoo! Groups Sponsor
> > >
> > >www..com
> > >
> >
> >
>_________________________________________________________________________
> > Get Your Private, Free E-mail from MSN Hotmail at
>http://www.hotmail.com.
> >
> >
> >
> >
> >
> >
>
>
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Home |
Main Index |
Thread Index
|