The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: New Node Zero


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: OT - Phone Plugs


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: OT - Phone Plugs
  • From: "Phil Harris" <phillip.harris1@xxxxxxx>
  • Date: Mon, 10 Dec 2001 10:23:35 -0000
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Be very careful feeding line level signals down speaker cable ... it's
unshielded and you'll pick up induced noise *VERY* easily.

Phil

-----Original Message-----
From: Dan Khan [mailto:dhk@xxxxxxx]
Sent: 10 December 2001 10:15
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] OT - Phone Plugs

Thanks, but I didn't explain myself well enough - I have speaker cable
that
terminates at a wall plate already - the other end of the cable runs
under
the carpet to the subwoofer location.  This end of the cable is bare
wire
and I need it to be a male phono plug.  This end just pokes up out of
the
carpet and needs to feed directly into the sub without having to install
a
new wall plate.

Any ideas?

Regards,
-Dan



-----Original Message-----
From: James Hoye [mailto:james.hoye@xxxxxxx]
Sent: 10 December 2001 10:06
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] OT - Phone Plugs


> After installing all of my speaker cabling terminating in wall plates,
I
> have run one for the subwoofer under the carpet.  Fair enough, but the
> subwoofer has a phono input not binding posts to attache the bare wire
-
> oops!.
>
> Anyone know where I can get a screw on phono plug to terminate the
bare
> cable?  I have tried m*plin, RS, and other UK sites listed in
> google with no
> success.

If you're handy with a drill and soldering iron, then for a couple of
quid
you too can build the following:

http://www.home-automation.info/images/phono_faceplate_front.JPG
http://www.home-automation.info/images/phono_faceplate_back.JPG

See 'tutorial' at
http://www.home-automation.info/make_speaker_terminal_wallplates.htm

James H



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/





For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/




Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.