[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: A quite stunningly "newbie" question :)
- To: <ukha_d@xxxxxxx>
- Subject: RE: A quite stunningly "newbie" question
:)
- From: "Des Gibbons" <des@xxxxxxx>
- Date: Mon, 10 Dec 2001 03:28:29 -0000
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
A din rail module is basically the same as a plug in module, except instead
of it being at the socket, its at the other end of the cable. You still
need
1 din rail module for each device you want to control. For lighting, you
need to modify your wiring to use din rail modules for each light.
HTH
Des
> -----Original Message-----
> From: Graham Butler [mailto:graham@xxxxxxx]
> Sent: 10 December 2001 03:21
> To: UKHA_D
> Subject: [ukha_d] A quite stunningly "newbie" question :)
>
>
> I've been seeing these DIN modules popping up all over the place while
> looking at X10 stuff and, having had zero experience with
> electrical wiring,
> was a little nonplussed. However, a little bit of surfing
> (doncha just love
> insomnia) and I think I've figured it out, so I guess I'm just after
> confirmation.
>
> As I understand it, these things connect directly to the mains,
therefore
> one module will control ALL things plugged into that section of the
mains?
> So if you had several appliances in one room that you wanted to have
> different X10 addresses, you'd most likely have to use plug-in modules
> bearing in mind the UK's predilection for ring mains?
>
> G
>
>
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe: ukha_d-subscribe@xxxxxxx
> Unsubscribe: ukha_d-unsubscribe@xxxxxxx
> List owner: ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
Home |
Main Index |
Thread Index
|