Re: Home Vision Question

[geraint@xxxxxxx]

Same idea as I had,,,,but my electronics weakness is my downfall.

What I need is an electonics wiz for hire !!!!!
We need to clone Mr Doxey and then send him round to people's houses
and lock him in until it is all complete.

I'm thinking of having a comfort system fitted, BUT NOT BY ME !
I wonder if the guys Andrew recommended for the install would be able
to do these bits and bobs ?

--- In ukha_d@y..., "Kenneth Watt" <kennethwatt@y...>
wrote:
> Geraint,
>
> I too have been looking into this in a bit of depth.
>
> I wanted to get the VisAccess
> (http://www.letsautomate.com/10483.cfm?cfid=46892&cftoken=28318)
and use
> that to send a signal to HV to open the doors and re-lock after a
> pre-determined time. A bit more secure I think than solely relying
on
> X10!
>
> HTH
>
> K.
>
> -----Original Message-----
> From: geraint@a... [mailto:geraint@xxxxxxx...]
>
> Sent: 07 August 2001 19:44
> To: ukha_d@y...
> Subject: [ukha_d] Home Vision Question
>
> Not got a homevision or even played/seen one.
>
> I have just got the first of my electronic locks for the doors...
>
> after all the messing around, I have left the standard five lever
> mortice locks in, but have now purchased electromagnetic ones for
> daytime convenience.
>
> The circuit takes 12v (via transformer) to power the magnet, so I
was
> thinking the easiest way was to hook this into an Appliance Module,
> wether plug in or Din Rail, so that I could switch off the circuit
> thus allowing entrance.
>
> Is there a way in Homevision to run a macro off a housecode ?
>
> Then I could send an x10 signal to turn off the appliance module,
but
> then say 5 seconds later it would turn back on again, thus securing
> the door.
>
> Thoughts ? Other ways maybe ?
>
> Regards
>
> Geraint.
>
>
>
>
>
> ____________________________________
> Automated Home UK
> http://www.automatedhome.co.uk
> ____________________________________
>
> Post message: ukha_d@y...
> Subscribe:  ukha_d-subscribe@y...
> Unsubscribe:  ukha_d-unsubscribe@y...
> List owner:  ukha_d-owner@y...
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com