[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Home Vision Question
- To: ukha_d@xxxxxxx
- Subject: Home Vision Question
- From: geraint@xxxxxxx
- Date: Tue, 07 Aug 2001 18:43:33 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
Not got a homevision or even played/seen one.
I have just got the first of my electronic locks for the doors...
after all the messing around, I have left the standard five lever
mortice locks in, but have now purchased electromagnetic ones for
daytime convenience.
The circuit takes 12v (via transformer) to power the magnet, so I was
thinking the easiest way was to hook this into an Appliance Module,
wether plug in or Din Rail, so that I could switch off the circuit
thus allowing entrance.
Is there a way in Homevision to run a macro off a housecode ?
Then I could send an x10 signal to turn off the appliance module, but
then say 5 seconds later it would turn back on again, thus securing
the door.
Thoughts ? Other ways maybe ?
Regards
Geraint.
Home |
Main Index |
Thread Index
|