The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

x10 problems


  • To: <ukha_d@xxxxxxx>
  • Subject: x10 problems
  • From: "Gareth Cook/STA/Lotus" <gcook@xxxxxxx>
  • Date: Mon, 9 Apr 2001 11:50:27 +0100
  • Delivered-to: rich@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx


OK Gang

I have various x10 modules. I have now plugged an appliance module into the
feed that powers the garage - it has it's own garage RCD unit. Sending any
commands to this device do NOT work.

But, I have a CM12 plugged into my PC (which is plugged into the garage
mains too) - and I can send commands to that (it's on the same bit of
wire), and it then can also send commands around the house. What I've had
to do it enable a macro - so I send an "On" command to code16
(mapped into
the Cm12) - which in turn send a command "On" for the unit 9 (the
appliance
module).

Any ideas ?

G.
-------------+-----------------------------+----------------+--------------------
(Embedded    Gareth Cook                  Office:  +44    Work:
image moved  Senior Engineering           (0) 1784 445    gcook@xxxxxxx
to file:     Specialist                   166             Personal:
pic26869.jpg GeT IT                       Mobile:  +44    g@xxxxxxx
)            Engineering,Networks,Securit (0) 7980 445    AOL AIM : theboyg
y                            166             Pager :
IBM SWG, Lotus Park,         Fax:      +44   gpage.csc1@xxxxxxx
Staines, TW18 3AG            (0) 1784 499    m
166
-------------+-----------------------------+----------------+--------------------


Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.