Re: powermid - reliability

["Andy Powell" <andy.powell@xxxxxxx>]

> Does the Powermid system work anyway close to being reliable?  I seem
> to remember a bit of bad press on some of the newsgroups a while back,
> is this still valid? Anyone got any personal experience?

The only thing that I remember about using Powermids was that when my wife
switched the Hoover on they would send out a stream of IR, sometimes the
response was so poor it would have been easier to get up and push the
buttons on the equipment, hence they were 'binned'.

Andy





**************************** DISCLAIMER *****************************

This message is intended only for use by the person to whom
it is addressed. It may contain information that is privileged and
confidential. Its content does not constitute a formal commitment by
Lombard Odier. If you are not the intended recipient of this message,
kindly notify the sender and destroy this message. Thank you.
*********************************************************************




------------------------------------------------------------------------
Body Paint, Chocolates, & Roses Oh My!
http://click.egroups.com/1/1159/3/_/2065/_/950084884/

-- Check out your group's private Chat room
-- http://www.egroups.com/ChatPage?listName=ukha_d&m=1