Re: Flaky CM12 ??

["paul gordon" <paul_gordon@xxxxxxx>]

As it happens, this failure has ocurred at exactly the same time as having
my Comfort system installed, & thereby adding a TW7223 onto the
powerline.
BUT, it doesn't seem to have affected anything else, only the CM12, - the
TW7223 has remained on the line throughout these problems, and whenever I
unplug the CM12 everything is 100% OK again, so I'm loathe to blame the
TW7223 or the Comfort panel, I prefer to think that this is a coincidence,
as it did also involve plugging the CM12 in & out a good few times....

Hmmm.....

PG.


>From: "Mike Huggins" <mikeh@xxxxxxx>
>Reply-To: ukha_d@xxxxxxx
>To: <ukha_d@xxxxxxx>
>Subject: [ukha_d] Re: Flaky CM12 ??
>Date: Mon, 25 Oct 1999 16:04:54 +0100
>
>This is probably total rubbish, but you haven't changed anything ELSE
have
>you ? I only ask, as I experienced a X10 "lock up" when I
installed some
>low
>voltage lights. It turned out that they were powered by "switch
mode" power
>supplies. The psu's were the problem.
>
>It went like this.
>
>Turn on a light or do anything X10 - OK
>Turn on LV lights - OK
>Try and turn them off - nothing
>Try and do anything thing else X10 - nothing.
>HARD switch them off (disconnect them) - all okay, and everything else
>CATCHES UP.
>
>HOWEVER
>
>I again, last week experienced a lock up. No particular reason that I
could
>find. By switching a certain light off, the lock up went away and all
has
>been fine since. Very strange...
>
>Mike
>
>
>
>
>------------------------------------------------------------------------
>
>eGroups.com home: http://www.egroups.com/group/ukha_d
>http://www.egroups.com -
Simplifying group communications
>
>
>
>

______________________________________________________

------------------------------------------------------------------------

eGroups.com home: http://www.egroups.com/group/ukha_d
http://www.egroups.com - Simplifying
group communications