The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: LCD Screen interfering with X10



What does switch mode mean?

Another thing to mention is that my logfile shows lots of commands received
like the following 'A777777777777 on, O33333333333 off.  Obviously
erroneous.

-----Original Message-----
From: Phil Harris [mailto:phil@xxxxxxx]
Sent: 30 March 2004 12:43
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] LCD Screen interfering with X10



> I use a cheap GNR 15 inch LCD monitor with about 6 appliance
> modules in the immediate vicinity without problems. I can
> operate these from both HV and local control via timers.

I think the problem - as we usually find - comes down to switch mode PSUs.
They're absolute buggers for banging out *HUGE* amounts of mains noise but
an X10 mains filter *SHOULD* cure it - if it doesn't then maybe there's a
fault with the filter?

Phil



UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.com

http://www.automatedhome.co.uk

Member Offers - http://www.freeranger.co.uk/ukha

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.